Now the 'B' pillar cover can be removed, pull extra slack out of the seat belt and return the seat to the rearward most position, holding the 'B' pillar cover out of the way. Here we pry the forward kick panel in the foot well loose, If you have factory phone there will be a speaker in this panel.Īdjust the passenger seat to the forward most position.

Pry the front door kick plate up at the clips, and remove. The wires pass in a boxed tube, and would have no problem to be fished through this conduit to the forward foot well.**** The wires pass in a boxed tube, and would have no problem to be fished through this conduit to the forward foot well.****įront door pry loose only clips for 'B' pillar.****This step may not be necessary, I took the time to remove the 'B' pillar cover so that I could see the wire run, and make sure it would not foul the seat belt mechanism. Rear door pry loose only clips for 'B' pillar.****This step may not be necessary, I took the time to remove the 'B' pillar cover so that I could see the wire run, and make sure it would not foul the seat belt mechanism. Pry the clips up as you lift on the finish panel. Remove 10mm plastic nut and expanding rivet from side finish panel. Rear door gently pry kick plate clips up, and remove plastic plate. Same for front passenger side, remove air conditioning grill and threshold seal both by hand. On passenger side, remove the threshold seal, this can be removed by hand. If after you remove the rear seat you smell gasoline you need to see your dealer, this cover is on the drivers side and covers the fuel pump and it has an update/recall. Time to start on interior, this pic is the rear seat and the release buttons under seat. note I have the spare tire and I removed it at this time.įorward right side of trunk this is the route the wires will take. This is what it looks like with the panels removed. Try to use a gradual bend them rather than a sharp fold. At this point you can remove all the panels, on the right and left side panels you must bend them and disengage them from the forward panel, this process requires some man handling of the panels.

Pry out the frames that surround the trunk lid hinges, I just taped them out of the way. Remove the cargo net anchors (2 each side)

Remove expanding rivets (2 each side) at the top by the trunk lid hinges. The victim, a 2004 E55 with Command, the SDS is programed to phone present (bluetooth puck with tail) this setting will allow the I-Pod integration to operate as plug and play.

For ipod instal FanControl v167